Superabrasive Cutting Tools · Technical Overview

PCBN & PCD inserts for hard turning and non-ferrous machining

A short technical overview of the grades, geometries and edge preparations we manufacture — prepared for engineers and purchasing teams evaluating hard-part turning as an alternative to grinding.

H Hard turning

PCBN grades for hardened steel in the HRC 45–65 range, covering continuous and interrupted cutting from roughing to finishing.

A Aluminium & non-ferrous

PCD inserts for aluminium, copper and other non-ferrous materials, including high-silicon alloys and mirror-finish requirements.

E Edge engineering

Chamfer and hone combinations matched to your operation, to control micro-chipping on interrupted cuts and stabilise tool life.

Grade families

Indicative positioning only — the right grade depends on hardness, interruption level and surface finish target.

FamilyWork materialTypical operationNotes
Low CBN contentHardened steel HRC 55–65Continuous finishingHighest wear resistance, best surface finish
Medium CBN contentHardened steel HRC 45–60Light interrupted, combined cutsBalance of toughness and wear resistance
High CBN contentHardened steel HRC 45–58Heavy interrupted, roughingMaximum edge strength under impact
PCDAl, Cu, non-ferrous, compositesTurning, boring, millingSharp edges, low adhesion, long life

Where it usually pays off

Typical applications where the process replaces or reduces grinding.

Hard turning instead of grinding

  • Bearing races and gear blanks after heat treatment
  • Shafts, pins and bushings in HRC 58–62
  • Reduced capital cost — no grinder, no coolant disposal
  • Flexible batch sizes, fast changeover

Aluminium and non-ferrous

  • Automotive transmission and pump housings
  • High-silicon aluminium (Si > 12%) with PCD
  • Mirror-finish boring without polishing
  • Composites and MMC where carbide wears fast

What we can support you with

Practical inputs, not just catalogue pages.

Process inputs

  • Recommended cutting parameters (Vc / f / ap) per grade
  • Edge preparation proposals for your interruption level
  • Insert geometry selection for your holder system
  • Comparison data against your current tool life

Supply formats

  • Finished inserts, ISO standard geometries
  • Custom geometries and edge specs on request
  • Blanks and semi-finished parts for tool makers
  • Batch consistency documentation available

Send us the part and the operation

Hardness, material, interruption type and your target cycle time is enough for us to come back with a grade proposal and starting parameters — usually within one working day.

Email engineering WhatsApp